Oki OKIFAX 5750 Service Manual page 364

27 Relay Print
28 600DPI Function
29 ISDN dial mode
to below 0.5 W.
1) Setting values
ON (Switched)/OFF (Not switched)
* When Default Type is set to 1 and Country Code is set to USA, the
Power Save mode cannot be selected.
* This mode cannot be made when ISDN or LAN board is installed.
Sets up whether to print picture received during relay reception.
1) Setting value
ON (print)/ OFF (not print)
* When in MEM mode, no printing if this setting is ON.
* In the case of OKIFAX 5750 device, setting is skipped.
(Only OKIFAX 5950 is operable.)
Sets up whether to effect communication and/or printing with 600 DPI x
600 DPI.
1) Setting value
ON/OFF
ON: Of 8MB memory, the DRAM area for 4MB is set aside as a shared
area for print buffer and the picture storage. Only when this area is not
in use, 600 dpi communication (transmission-reception) and copying
will
be enabled.
OFF: Option memory of 8MB is all used for storing pictures. Therefore,
resolution of communication and copying remain unchanged from
conventional data (not for 600 dpi).
* Setting enabled only when 8MB optional memory is installed. If
pictures received with 600 dpi are present in the picture memory,
"ILLEGAL OPERATION" warning will be displayed when shifting to the
lowest hierarchy.
Determine whether G4 communication is to be performed by calling a
single remote machine by pressing ten-keys when an ISDN option is
provided.
1) Setting values
G3 mode (G3 communication)/G4 mode (G4 com-munication)
* This setting cannot be made when an ISDN option is not provided.