Menu: Switch-To-Switch Download To Primary Flash - HP ProCurve Management And Configuration Manual

Menu: Switch-to-Switch Download to Primary Flash

Using the menu interface, you can download a switch software file from either
the primary or secondary flash of one switch to the primary flash of another
switch of the same series.
1. From the switch console Main Menu in the switch to receive the down­
load, select 7. Download OS screen.
2. Ensure that the Method parameter is set to TFTP (the default).
3. In the TFTP Server field, enter the IP address of the remote switch contain­
ing the software file you want to download.
4. For the Remote File Name, enter one of the following:
• To download the software in the primary flash of the source switch,
type "flash" in lowercase characters.
• To download the software in the secondary flash of the source switch,
type
/os/secondary.
5. Press , then
[Enter]
6. A "progress" bar indicates the progress of the download. When the entire
switch software download has been received, all activity on the switch
halts and the following messages appear:
Validating and writing system software to FLASH...
7. After the primary flash memory has been updated with the new software,
you must reboot the switch to implement the newly downloaded software.
Return to the Main Menu and press
see this prompt:
Continue reboot of system? : No
Press the space bar once to change No to Yes, then press
the reboot.
8. To confirm that the software downloaded correctly:
a. From the Main Menu, select
Status and Counters
General System Information
b. Check the Firmware revision line.
(for eXecute) to begin the software download.
[X]
(for Reboot Switch). You will then
[6]
File Transfers
Downloading Switch Software
to begin
[Enter]
A-21