HP ProCurve Management And Configuration Manual page 317

The show running command displays the currently applied setting for any
interfaces in the switch configured for all traffic rate-limiting and ICMP rate
limiting. The show config command displays this information for the configu­
ration currently stored in the startup-config file. (Note that configuration
changes performed with the CLI, but not followed by a write mem command
do not appear in the startup-config file.)
ProCurve Switch 8212zl# show config
Startup configuration:
; J8697A Configuration Editor; Created on release #K.12.XX
hostname "ProCurve Switch 8212zl"
module 1 type J8705A
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged A1-A24
ip address dhcp-bootp
exit
interface A1
rate-limit all out bps 100000
exit
interface A2
rate-limit all out bps 100000
exit
interface A3
rate-limit all out bps 100000
exit
interface A4
rate-limit all out bps 100000
exit
interface A5
rate-limit icmp 60
exit
interface A6
rate-limit icmp 60
exit
Figure 13-2. Example of Rate-Limit Settings Listed in the "show config" Output
Port Traffic Controls
Ports A1-A4 are configured with an
outbound rate limit of 100,000 bps.
Ports A3-A5 are configured with a
rate limit for icmp traffic of 60 %.
Rate-Limiting
13-7