HP ProCurve Management And Configuration Manual page 583

Syntax: chassislocate [ blink | on | off ]
ProCurve(config)# chassislocate
blink <1-1440>
off
on <1-1440>
ProCurve(config)# chassislocate
Figure B-37. The chassislocate Command
Locate a device by using the blue Locate LED on the front panel.
blink <1-1440>
Blinks the chassis Locate LED for a selected number of minutes
(default is 30 minutes).
on <1-1440>
Turns the chassis Locate LED on for a selected number of minutes
(default is 30 minutes).
off
Turns the chassis Locate LED off.
Blink the chassis locate led (default 30 minutes).
Turn the chassis locate led off.
Turn the chassis locate led on (default 30 minutes).
For redundant management systems, if the active management module per­
forms a switchover, the Locator LED does not remain lit.
Monitoring and Analyzing Switch Operation
Locating a Device
B-73