HP ProCurve Management And Configuration Manual page 457

ProCurve(config)# reload
This command will cause a switchover to the other management module
which may not be running the same software image and configurations.
Do you want to continue [y/n]? y
(Boots....)
ProCurve(config)# show redundancy
Settings
--------
Mgmt Redundancy : Enabled
Statistics
----------
Failovers
Last Failover : Mon April 30 09:10:11 2007
Slot Module Description
---- ---------------------------------------- -------- ---------- ----------
MM1 ProCurve J9092A Management Module 8200zl Active
MM2 ProCurve J9092A Management Module 8200zl Standby
Figure 15-25. Example of Reload Command with Redundancy Enabled
Command
reload <cr>
: 1
Existing CLI Commands Affected by Redundant Management
Action
Boots (warm reboot) the active management module.
Switchover to the standby management module occurs if
redundancy is enabled. If redundancy is disabled or there is no
standby management module, the
system.
Note: If the running config file is different from the stored config
file, you will be prompted to save the config file. The
at/after
versions of this command do not display a prompt to
save configuration file changes; the changes are lost on the
scheduled reload.
Status
Redundancy (Switch 8212zl)
reload
command boots the
reload
SW Version Boot Image
K.12.30 Primary
K.12.30 Primary
15-33