HP ProCurve Management And Configuration Manual page 575

Mirror Session Identity from
the Source Switch (Session
1 on Both Switches)
Switch-D(config)# mirror endpoint 10.10.10.119 9300 10.10.30.2 port a15
Switch-D(config)# mirror endpoint 10.10.20.145 9300 10.10.30.2 port a15
Figure B-30. Example of Configuring Remote Mirroring from Switches A and B on the Destination Switch
1
Switch-A(config)# mirror 1 remote ip 10.10.10.119 9300 10.10.30.2
Caution: Please configure destination switch first.
Do you want to continue [y/n]? y
2
Switch-A(config)# access-list 100 permit tcp any host 10.10.30.153
eq telnet
3
Switch-A(config)# vlan 10 monitor ip access-group 100 in mirror 1
Figure B-31. Example of Configuring Remote Mirroring of Inbound Traffic on Source Switch 1
Mirror Session 1 Identity
Name of ACL
ACL Applied to this Mirror Session
1
Uses the source IP address and random UDP port number to identify session 1 mirrored
traffic from VLAN 10, and specifies the destination IP address for this traffic. (The mirror
exit port for this traffic is a member of the VLAN identified by the destination IP address.)
2
Configures an ACL with a permit entry (ACE) that mirrors Telnet traffic entering switch 1
on VLAN 10 if their destination is the server at 10.10.30.153. (The implicit deny included in
all ACLs prevents all other inbound traffic from being mirrored.)
Configures VLAN 10 as the source of traffic to mirror, and the ACL as the selection criteria
3
for inbound traffic on VLAN 10 for mirror session 1.
Monitoring and Analyzing Switch Operation
Mirror Session Destination
IP Address
Mirror Session Destination
Criteria for Traffic Selection
Mirror Session
Traffic Mirroring
Mirror Session
Exit Port
B-65