HP ProCurve Management And Configuration Manual page 365

Example of
ProCurve(config)# show snmp-server
Community
SNMP Communities
Name Data (See
Community Name
page 14-11.)
---------------- -------- ------------
public
blue-team
red-team
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Example of Trap
Receiver Data
Address
---------------------- ---------------- -------------------
10.28.227.200
10.28.227.105
10.28.227.120
Figure 14-9. Example of Show SNMP-Server Listing
N o t e
MIB View Write Access
Operator Restricted
Manager
Manager
Configuring Trap Receivers. This command specifies trap receivers by
community membership, management station IP address, and the type of
Event Log messages to send to the trap receiver.
If you specify a community name that does not exist—that is, has not yet been
configured on the switch—the switch still accepts the trap receiver
assignment. However, no traps will be sent to that trap receiver until the
community to which it belongs has been configured on the switch.
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Unrestricted
Unrestricted
Community Events Sent in Trap
public All
red-team Critical
blue-team Not-INFO
Authentication
Trap Setting
14-21