Using Redundant Management; Displaying Redundancy Status - HP ProCurve Management And Configuration Manual

N o t e

Using Redundant Management

There are new CLI commands for redundant management as well as
modifications to existing commands. (See "Existing CLI Commands Affected
by Redundant Management" on page 15-29)
New Redundant Management Commands
show redundancy
redundancy management-module
redundancy switchover
redundancy active-management
redundancy fabric-module

Displaying Redundancy Status

You should be at the global configuration level when executing these
commands, that is, Procurve(config)# as shown in the examples.
You can display the status of both the management and fabric redundant
modules using this command:
Syntax: show redundancy
Displays the status of the management and fabric modules.
An example of the output for the show redundancy command is seen in Figure
15-1.
Redundancy (Switch 8212zl)
Using Redundant Management
Page
15-5;15-26
page 15-6
15-8
15-9
15-12
15-5