Error Codes And Diagnostic Codes - Invacare Orion Service Manual

SERVICE MANUAL
Scooter
judders in
drive mode
Batteries
not being
charged
Scooter
runs too
slowly
6.2

Error Codes and Diagnostic Codes

Blink
code
1
2
3
4
18
None Drive motor(s)
possibly defective
Drive lever
potentiometer
possibly defective
None Batteries possibly
defective
LEDs blinking Charging device
on charging unit possibly defective
None Operating
console possibly
defective
Batteries possibly
defective
Fault Consequence
for the Scooter
Battery must be Continues to
charged drive
Battery voltage too Stops driving
low
Battery voltage too Stops driving
high
Power time Stops driving
exceeded
· Replace
See "Replacing the
motor(s)
drive motor" on page 20
· Replacing the
See "Replacing the
potentiometer
potentiometer" on page
42
· Replace
See operating manual
batteries
· Replace
See charging unit
charging unit
operating manual
· Replace
See "Replacing
operating
operating console" on
console
page 38
· Replace
See operating manual
batteries
Comments
·
The batteries are discharged. Charge the
battery as soon as possible.
·
The batteries are depleted. Charge
batteries.
·
If you switch the Scooter off for a few
minutes, the battery can often recuperate
to such a stage that a short journey is
still possible.
·
The battery voltage is too high. If the
battery charger is connected, disconnect
it from the Scooter.
·
The electronic system charges the
batteries when running downhill and
when braking. This fault is caused when
the battery voltage becomes too high
during this process. Switch the Scooter
off and on again.
·
The maximum current was exceeded
over too long a period, probably because
the motor was overloaded or has been
working against an immovable
resistance. Switch the scooter off, wait a
few minutes and then switch on again.
·
The electronic system has determined a
motor short-circuit. Check the wiring
harness for short-circuit and check the
motor.
·
Contact your Invacare® dealer.
®
Invacare - Orion