®
Invacare
- Orion
7.8
Replacing brake cable
ATTENTION! Risk of accident.
Accidental rolling can lead to accidents.
· Secure the scooter against rolling away.
Note:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Note:
You do NOT need to remove the wheel to replace the brake cable.
Requirements:
· Open spanner, 10 mm.
· Phillips screwdriver
·
Decrease the brake tension on the wheel
using the setting screw (1).
·
Disconnect the brake cable at the wheel (2).
·
Disconnect brake cable at steering wheel
brake lever.
·
Route the brake cable through the cladding.
·
Loosen brake lever screw (3) at wheel.
·
Replace brake cable.
·
Reassembly of the brake cable takes place
in reverse order.
·
Check braking function while pushing.
SERVICE MANUAL
33