Repair Work; General Warning Information On Installation Work; Replacing The Drive Motor - Invacare Orion Service Manual

SERVICE MANUAL
7

Repair Work

7.1

General warning information on installation work

CAUTION!
Risk of damage to the vehicle! Collisions can be caused if shim rings are removed from
the drive wheels during installation work!
Shim rings are frequently placed between the drive shaft and the wheel hub to compensate
tolerances. Collisions can be caused if these shim rings are removed and not re-installed!
· Install all shim rings in exactly the same positions they were in before dismantling.
7.2

Replacing the drive motor

ATTENTION! Risk of accident.
When parking the scooter on the scooters support wheels it is no longer slowed by the
engine brake. The scooter can roll away out of control.
· Place the scooter rear frame on a supporting wooden block before you remove the wheels.
ATTENTION! Risk of accident.
Accidental rolling can lead to accidents.
· Secure the scooter against rolling away.
Note:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Note:
The plugs on the electronic module cannot be wrongly connected because all plugs have a
different size and only fit in one socket.
Requirements:
· Open spanner, 10 mm.
· Open spanner, 17 mm.
· oblique pliers
· Rubber hammer
· Phillips screwdriver
· Supporting wooden block
20
®
Invacare - Orion