Replacing Brakes - Invacare Orion Service Manual

®
Invacare - Orion
7.7

Replacing brakes

ATTENTION! Risk of accident.
Accidental rolling can lead to accidents.
· Secure the scooter against rolling away.
Note:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Note:
The front axle can only be replaced on the 3-wheel version. The 4-wheel version does not have a
replaceable axle.
Requirements:
· Open spanner, 10 mm.
· Open spanner, 17 mm.
· Open spanner, 19 mm.
· Supporting wooden block
·
Remove the seat.
·
Remove motor cover.
·
Separate battery cable.
·
Place a supporting wooden block under the
front part of the frame so that the front wheel
is no longer touching the floor.
3-wheel version:
·
Slacken brake cable (see chapter entitled
"Replacing brake cable" on page 33).
·
Disconnect brake cable at wheel.
·
Loosen axle bolts (1) simultaneously on both
sides.
·
Pull front axle slowly out.
4-wheel version:
·
Slacken both brake cables.
·
Disconnect brake cable at affected wheel.
·
Loosen wheel bolt.
·
Pull wheel and brake off shaft.
SERVICE MANUAL
31