Invacare Orion Service Manual page 12

SERVICE MANUAL
CAUTION!
Danger of burns from hot surfaces on the motor!
· Allow the motors to cool down before commencing work on them.
ATTENTION!
Injury hazard and danger of damage to vehicle due to improper or incomplete
maintenance work!
· Use only undamaged tools in good condition.
· Some moving parts are mounted in sockets with PTFE coating (Teflon™). Never grease
these sockets!
· Never use "normal" nuts instead of self-locking nuts.
· Always use correctly-dimensioned washers and spacers
· When reassembling, always replace any cable ties which were cut during dismantling.
· After completing your work / before renewed start-up of the mobility device, check all
connections for tight fitting.
· After completing your work / before renewed start-up of the mobility device, check all parts for
correct locking.
· Only operate the vehicle with the approved tyre pressures (see technical data).
· Check all electrical components for correct function. Please note that incorrect polarity can
result in damage to the electronic.
· Always carry out a trial run at the end of your work.
Note
Mark all current settings for the mobility aid (seat, armrests, backrest etc.), and the associated
cable connecting plugs, before dismantling. This makes reassembly easier.
All plugs are fitted with mechanical safety devices which prevent release of the connecting plugs
during operation. To release the connecting plugs the safety devices must be pressed in. When
reassembling ensure that these safety devices are correctly engaged.
WARNING!
Any changes to the drive program can affect the driving characteristics and the tipping
stability of the vehicle!
· Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
· Invacare® supplies all mobility aids with a standard drive program ex-works. Invacare® can
only give a warranty for safe vehicle driving behaviour - especially tipping stability - for this
standard drive program!
12
®
Invacare - Orion