Error Codes And Diagnostic Codes - Invacare Leo Service Manual

®
Invacare - Leo
Scooter
judders in
drive mode
Batteries
not being
charged
Scooter
runs too
slowly
Scooter
does not
reduce
speed on
bends.
5.2

Error Codes and Diagnostic Codes

Blink
code
1
2
3
None Drive motor
defective
Drive lever
potentiometer
defective
None batteries
defective
LEDs blinking Charging unit
on charging unit defective
None Operating
console defective
batteries
defective
Speed reducer for
None
bend travel not
adjusted.
Speed reducer
defective
Fault Consequence
for the Scooter
Battery must be Continues to
charged drive
Battery voltage too Stops driving
low
Battery voltage too Stops driving
high
· Replace
See "Replacing the
motor(s)
drive motor" on page
19
· Replacing the
See "Replacing the
potentiometer
potentiometer" on page
38
· Replace
See operating manual
batteries
· Replace
See charging unit
charging unit
operating manual
· Replace
See "Replacing
operating
operating console" on
console
page 36
· Replace
See operating manual
batteries
· Adjust speed
reducer
· Replace speed
See chapter "Replacing
reducer
speed reducer".
Comments
·
The batteries are discharged. Charge the
battery as soon as possible.
·
The batteries are depleted. Charge
batteries.
·
If you switch the Scooter off for a few
minutes, the battery can often recuperate
to such a stage that a short journey is
still possible.
·
The battery voltage is too high. If the
battery charger is connected, disconnect
it from the Scooter.
·
The electronic system charges the
batteries when running downhill and
when braking. This fault is caused when
the battery voltage becomes too high
during this process. Switch the Scooter
off and on again.
SERVICE MANUAL
17