Toa TS-800 Series Operating Instructions Manual page 33

Attaching a CC-4900 BNC Plug to the 3C-FB Cable
Step 1. Strip the jacket 10 mm from the end of the
coaxial cable.
Step 2. Slip the tube supplied with the BNC plug over the
jacket.
Step 3. Unravel the braided shield and turn it back, then
peel away the aluminum cladding.
Step 4. Strip the dielectric 4 mm from the cable end.
Step 5. Disassemble the BNC plug as shown in the
figure at right.
Step 6. Insert the coaxial cable into the clamping fixture.
Step 7. Insert the clamping fixture assembly into the plug
and then solder the conductor.
Step 8. Insert the plug into the BNC connector.
Step 9. Clamp the connector by tightening the clamping
fixture.
Braided shield
10 mm
Aluminum cladding
Dielectric
Conductor
4 mm
Clamping fixture Plug
Clamping fixture
Conductor
Solder.
Clamping fixture BNC connector
(Finished)
Tube
BNC connector
BNC connector
33