Omron BN75R Instruction Manual page 44

Setting Local Setting
In/Out Settings
Boot Settings
Battery Settings
Menu
Language
LCD Setting
LCD Auto off
LCD Test
Audible Alarm
Calendar Setting
UPS Installation
UPS Life Count
Menu Type
Output Voltage ☆
AC I/P Sensitivity ☆
Input Plug ☆
ECO Mode ☆
Frequency Range ☆
Transfer Sensitivity ☆
Auto Reboot
Cold Start
Reboot Delay Time
Load Segments
Reboot Batt.level
Auto Reboot Mode
Power SW Off Mode
Function Test
Batt.life Counter
Battery Installation
Max.backupTime ☆
Low Battery Warning ☆
75 150
BN R/BN R/BN
Description
Set the language to be displayed on
the LCD.
Change the contrast of the LCD.
Set the amount of time after which the
LCD turns off automatically.
Check that the LCD and LEDs light up.
Set the beeper status.
Set the calendar information for the
UPS.
Set the date you started using the UPS.
Set the UPS life counter status.
Select the menu to be displayed.
"Standard" displays frequently used
items only.
Check the output voltage.
Set the input sensitivity.
Set this when replacing the input plug.
Set whether to enable ECO Mode.
Switch the frequency range mode.
Set the sensitivity at which to switch to
Battery Mode.
Set auto restart from power failure.
Set whether to enable the cold start
function that can start up the UPS even
when there is no AC input.
Set the delay time for recovery from
power failure.
Set this when you want the delay time
for restarting receptacle group B and C
to be longer than that for group A.
Set the amount of battery charge for
restarting the UPS.
Set the mode for rebooting.
Switch the operating mode of the power
switch.
Set the timing at which to execute the
self-diagnostic test.
Set whether to be notified of the battery
life.
Set the date you replaced the battery.
Set the output of the UPS to stop after
a specified amount of time.
Set the level at which to detect low
battery.
300
R
4
32