Applications - Crestron TPMC-4XG Operation Manual

Crestron TPMC-4XG
Operations Guide – DOC. 6655B

Applications

The following diagram illustrates a basic configuration that connects a TPMC-4XG
WiFi touchpanel to a control system via a wireless access point (WAP).
802.11b/g
W IC0 W IC0 ETH
PW R
ACT/CH0 ACT/CH0 ACT
OK CO L
ACT/CH1 ACT/CH1
Access
Point
Ethernet
7x 8x 9x 10x 11x 12x 7x 8x 9x 10x 11x
C
7 8 91011 12
A 1 2 3 4 5 6
1x 2x 3x 4x 5x 6x 1x 2x 3x 4x 5x
A B
Hub/
Switch/
Router
Ethernet
Control
System
•
The distance between the TPMC-4XG and the dedicated WAP should not
exceed 30 feet. The TPMC-4XG is not a roaming device.
•
Use a dedicated wireless router/access point for each TPMC-4XG device.
The diagram on the next page presents a more complex configuration. In this
scenario, the WAP is connected to port B of the control system's C2ENET-2 card.
Port A is connected to the corporate LAN. The card's internal firewall controls data
flow thus isolating the two subnets.
NOTE: When using a dual-port Ethernet card, Ports A & B must be different
subnets (e.g., Port A = 128.x.x.x; Port B = 192.x.x.x).
For additional information on setting up and understanding an Ethernet network,
refer to the latest version of the Crestron e-Control Reference Guide (Doc. 6052),
which is available from the Crestron website (www.crestron.com/manuals).
Isys i/O™ Handheld WiFi Touchpanel
12x
6x
Isys i/O™ Handheld WiFi Touchpanel: TPMC-4XG • 3
802.11b/g
TPMC-4XG
Internet