Assembling Saw Stand; Assembly Instructions - Delta 36-477 Instruction Manual

ASSEMBLING SAW STAND

1. Assemble the dust chute and support panel (A)
Fig. 8, to the inside of the front stand panel (B) with three
#10 x 1/2 sheet metal screws (C), four #10-32 x 1/2
screws (D), and four hex nuts (E). Fig. 9 illustrates the
dust chute and support panel (A) assembled to the front
of stand (B). NOTE: The front stand panel will have the
saw identity labels facing you. Do not completely tight-
en the stand hardware at this time. Also, make certain
the dust chute/support panel (A) Fig. 9, is located under
the lip of front stand panel (B).
2. Assemble the other end of dust chute and support
panel (A) Fig. 10, to rear stand panel (F) as shown with
four #10-32 x 1/2 screws and hex nuts, three of which
are shown at (D). NOTE: Do not completely tighten stand
hardware at this time.

ASSEMBLY INSTRUCTIONS

F
D
9
D
A
Fig. 8
A
Fig. 9
D A
Fig. 10
B
C
E
B