Table of Contents
Advertisement
ASSEMBLING
M O TO R PULLEY
Assemble motor pulley (A) Fig. 14, to the motor shaft
making certain set screw (B) in the motor pulley engages
with key (C) in motor shaft .
ASSEMBLING B A N D S AW
TO STA N D
1 . Carefully place the band saw (A) Fig. 15, onto the
band saw stand (B). NOTE: Position the band saw so the
pulley (C) is over the opening (D) in the stand.
2 . Align the four holes in the base of the band saw with
the four mounting holes in the top of the stand and
fasten the band saw to the stand with four 5/16-18 x
1-3/4 hex head screws, three of which are shown at (E)
Fig. 15, with flat washers and flange nuts .
ASSEMBLING A N D
ALIGNING V-BELT;
ADJUSTING B E LT TENSION
1 . Using a straight edge, align motor pulley (A) F i g . 1 6 ,
to the driven pulley (B). If necessary, both pulleys can be
adjusted inward or outward. The motor (C) can also be
adjusted on the motor mounting bars (D).
2 . Assemble the V-belt (E) Fig. 16, to pulleys (A) and
(B) and adjust the belt tension by raising or lowering the
motor (C) on the motor mounting bars (D). If necessary,
the motor mounting bars (D) can be repositioned on two
v e r t i c a l p o s ts ( F ) . NOTE: Make certain the pulleys are
kept in alignment when doing this. Correct belt tension is
o b tained when there is approximately 1 deflection, using
light finger pressure at the centerspa n o f t h e p u l l e y s .
A
E
B
E
D
F
8
B
C
Fig. 14
C
A
E
D
Fig. 15
C
A
Fig. 16
B
Hide quick links:
Advertisement
Table of Contents
