Assembling Saw To Stand; Assembly Instructions - Delta 36-600 Instruction Manual

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER
SOURCE UNTIL THE TOOL IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND
UNDERSTAND THE ENTIRE OWNERS MANUAL.
ASSEMBLING STAND
1. Assemble stand as shown in Fig. 4 and 5 using parts
shown in Fig. 3. The braces, legs and feet are labeled the
same in all three illustrations. Insert screws through legs
and braces then place washer on screw and secure with
nut. Only tighten nuts finger-tight at this time. NOTE:
The top lips of the two top side braces (A) must fit on top
of the top lips of the front and rear braces (B). The side
braces (A) have holes on top for mounting the saw to the
stand. Only tighten hex nuts finger-tight at this time.
ASSEMBLING SAW
TO STAND
1. Position the saw (B) on the stand as shown in Fig. 6,
lining up the four holes on the bottom of sides of the saw
cabinet with the four holes in the two top side braces,
one of which is shown at (A).
2. Fasten the saw to the stand using the four 16MM
long hex head screws, eight flat washers and four hex
nuts supplied.
3. Push down on top of saw so the legs of the stand
adjust to the surface of the floor and tighten all stand
mounting hardware.

ASSEMBLY INSTRUCTIONS

9
8
4
A
9
1
9
3
8
2
Fig. 4
3
4
4
Fig. 5
B
Fig. 6