D
A
3. Using the template (D) Figures 78 and 79, check and adjust front rail at both ends of the saw table as shown, to
make sure rail (A) is level with table surface and tighten rail mounting hardware (B). IMPORTANT: Template (D) must
be on saw table when checking, not on extension wing.
4. Assemble rear rail (E) Fig. 80, to rear of saw table using the two 3/8-24 x 1-1/4 long hex head screws (F), 7/8 flat
washers and lockwashers as shown.
5
Make certain top edge of rail (E) Fig. 80 is below table surface and that top edge of cut-outs (G) are below miter
gage slots before tightening screws (F).
6. If you did not purchase the accessory right extension table for use with your
T-Square
shown in Fig. 81.
B
Fig. 79
®
fence, construct an extension table by following the dimensions
E
Fig. 81
26
F
Fig. 80