Delta 36-477 Instruction Manual page 16

9. With the blade guard (L) Fig. 35, in the raised posi-
tion, assemble the saw blade (K) on the saw arbor with
two arbor wrenches supplied.
10. Using a straight edge, check to see if the saw blade
is aligned with the rear of the splitter (G), as shown in
Figs. 36 and 37. If alignment is necessary, loosen the
screws (A) Fig. 37, align splitter (G) with the saw blade,
and tighten two screws (A).
11. Lower saw blade and install table insert (P) Fig. 38,
in the saw table as shown. IMPORTANT: When installing
the table insert, always make certain to hold on to the
blade guard (L). The insert will automatically release the
holding action on the splitter and lower the blade guard
when it is installed in the table opening.
L
K
G
16
Fig. 35
Fig. 36
A
Fig. 37
P
Fig. 38
G
L