Delta 36-477 Instruction Manual page 27

²
1- 3/4 (K)
7. Mark the position of the four leg mounting holes from
each end of the table as shown in Fig. 82. Using a 1/4
drill bit, drill four through holes through the end piece (J)
of the table at the dimensions shown at (K) (L) and (M).
8. Position the two legs (H) as shown in Fig. 83.
Assemble the four 1/4-20 x 1-1/2 long leg mounting
screws, washers and hex nuts (I) into holes drilled in step
7 and tighten. Mark the eight holes (P) to attach the legs
to the table top. Remove the screws and two legs (H).
Using a 1/16 drill bit, drill the eight holes 1/2 deep.
IMPORTANT NOTE: If your saw and fence system will
be used with a mobile base underneath the saw base
and table legs, the position of the legs may have to
be changed to fit onto the mobile base.
9. Fasten the leg bracket (L) Fig. 84, to the underside of table top using the eight 3/4 long wood screws (N). Assemble
the four 1-1/2 long flat head Phillips screws, flat washers and hex nuts (I) to the end piece (J) of the table and retight-
en. Fasten the remaining leg to the extension table in the same manner.
10. Place table assembly (N) Fig. 85, in position between the two rails, as shown. Make sure end of table (O) is flush
against saw table (P) and using a bar clamp (Q) snug up end of rails to hold table in position. Using a straight edge
make sure table (O) is in the same plane and level with saw table (P). Lightly tap table up or down and adjust leveling
screws (R) Fig. 86, in bottom of legs to accomplish this. When you are certain table (O) Fig. 85, is level and in the same
plane with saw table (P), tighten bar clamp (Q) to hold everything in position. Then drill 1/4 through holes through the
front and rear of the extension table using the holes (S) provided in rails as template.
S
²
5- 3/8 (M)
²
2- 3/8 (L)
J
Fig. 82
P
Fig. 85
P
J
O
N
Q
27
H
I
Fig. 83
L
N
Fig. 84
R
Fig. 86
P
I