Delta 36-477 Instruction Manual page 19

UNIFENCE ASSEMBLY INSTRUCTIONS
ASSEMBLING TABLE LEGS AND FRONT TABLE SUPPORT
1. The table board supplied will require thirteen loca-
tions to be marked on the bottom of the table board at
the locations illustrated in Fig. 48. NOTE: The table
board should be positioned so that the edge with no
veneer is on the side that will be attached to the exten-
sion wing. Turn the table board upside-down with the
raw edge to the left for leg hardware mounting.
2. Assemble table leg (A) Fig. 49, to table board (B) using
four #8 x 7/8 long wood screws (C) as shown. Assemble
remaining table leg to the table in the same manner.
CAUTION: DO NOT OVER-TIGHTEN LEG MOUNTING
SCREWS. Over-tightening screws in particle board may
cause them to strip.
3. Fasten front table support (D) Fig. 50, to the bottom
of table using two 7/8 long wood screws (E) as shown.
CAUTION: DO NOT OVER-TIGHTEN SCREWS (E).
Over-tightening screws in particle board may cause them
to strip. Do not completely tighten the two screws (E) at
this time, as adjustment is necessary.
Fig. 48
D
E
19
A
B
C
Fig. 49
E
Fig. 50