Assembling Unifence Guide Rail - Delta 36-477 Instruction Manual

ASSEMBLING
UNIFENCE GUIDE RAIL
1. Locate the T-Slot Guide Rail and mounting hardware
Fig. 59, from the packing material of the Unifence.
Remove the end caps (A) Fig. 59, prior to assembly, by
inserting a flat headed screwdriver (B) into the channel
and tap gently as shown. NOTE: Take care not to dam-
age either the cap or the rail.
2. Insert two 3/8-24 x 1 hex head bolts, flat washers
and hex nuts (C) Fig. 60, into the two holes (F) Fig. 60 in
the front of saw table (G). Screw bolts into nuts slightly
leaving bolt head extended approximately 1/2 . Note:
Make sure to use only the two holes shown at (F).
3. Insert one 1/4-20 x 3/4 hex head bolt, flat washer and
hex nut (D) Fig. 60, into the front support of the extension
table (E) Fig. 60. Screw bolt into nut slightly leaving bolt
head extended approximately 1/4 .
4. From either end, slide the T-Slot guide rail (A) Fig.
61, onto the hex head of the bolts partially inserted in
step 2 and 3 above. Note: The bolt heads on the saw
table slide into the upper t-slot (B) Fig. 61 and the bolt
head on the extension table slide into the lower t-slot (C)
Fig. 61.
5. Slide the guide rail along until the "0" on the unifence
scale is aligned with the right edge of the saw table.
snugg the hex nuts on the saw and extension table but
do not tighten at this time.
6. Adjust the guide rail (C) Fig. 62, parallel with the saw
table surface by placing a square (H) on the saw table at
both the left front ends of the saw table (A) and the right
front end of the extension table (B), with the rule of the
square against the flat surface on top of the guide rail.
The guide rail (C) Fig. 62, can be adjusted up or down
slightly at either end. After you are certain the guide rail
is parallel with the table surface, firmly tighten the two
hex nuts that fasten the guide rail to the table. Note:
Make sure "0" (D) on the unifence scale is aligned with
the right edge of the saw table (E).
B
A
G
H
A
C
22
Fig. 59
E
F
Fig. 60
A
Fig. 61
E
D
"0"
Fig. 62
A
D
C
B
C
B