Delta 36-477 Instruction Manual page 13

7. Lift the motor and assemble the drive belt (H) Fig.
23, to the arbor pulley and motor pulley (B). The weight
of the motor will provide the correct belt tension.
8. WARNING: IMMEDIATELY AFTER ASSEMBLING
THE BELT, RAISE THE SAW BLADE TO ITS MAXIMUM
HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES.
CHECK TO SEE IF THE MOTOR (J) FIG. 24, IS BELOW
THE TOP OF THE TABLE SURFACE (K). IF THE
MOTOR (J) IS ABOVE THE TOP OF THE TABLE SUR-
FACE, THE MOTOR MUST BE MOVED TO THE LEFT
UNTIL YOU ARE CERTAIN THE END BELL (J) OF THE
MOTOR IS BELOW THE TOP OF THE TABLE SUR-
FACE. THEN RE-ALIGN THE MOTOR PULLEY TO THE
ARBOR PULLEY.
9. Assemble the outer cover (E) Fig. 25, of the belt and
pulley guard assembly, which was removed in STEP 3,
and fasten with external tooth lockwasher and wing nut
(D). IMPORTANT: Make certain the outer cover does not
interfere with the drive belt and the motor pulley.
CONNECTING MOTOR CORD
TO SWITCH ASSEMBLY
WARNING: BEFORE CONNECTING MOTOR CORD TO
THE SWITCH ASSEMBLY, MAKE CERTAIN THE SAW
IS DISCONNECTED FROM THE POWER SOURCE.
1. Insert the pronged motor plug (A) Fig. 26, into the
female receptacle (B) of switch-to-motor cord (C).
H
B
D
13
Fig. 23
J
K
Fig. 24
E
Fig. 25
C
B
A
Fig. 26