Begin The Initialization Process; Nn10319; If Your Network Supports Dhcp - Nortel i2002 User Manual

Standard—Nortel Networks Confidential
86 Setting DHCP parameters

Begin the initialization process

To begin the initialization process, at the flashing Nortel Networks screen, quickly
press each of the four softkeys (located at the bottom of the display screen) once,
pressing from left to right.
If your network supports DHCP go to
DHCP go to

If your network supports DHCP

1
If your i2002 network supports DHCP, enter the configuration parameters at
the prompt in the display area of your phone as described in the following
table.
Parameter
DHCP (enable)
DHCP (full or partial)
S1 IP
S1 PORT
S1 ACTION
S1 RETRY Count

NN10319-111

Tip: If you miss the flashing introduction screen, unplug and plug in
your i2002 Internet Telephone to reach the configuration screen where
you can press the softkeys.
page 87.
Tip: You may need to contact your system administrator to check
whether your network supports DHCP.
Value
1
1
<valid Server IP address>
5000
1
1
page 86. If your network does not support
Definition
Yes
Partial
Primary server (IP Client
Manager or Multimedia PC
Client) IP address
Primary server port
Primary action code (must
be set to 1)
Primary retry count