Table of Contents
Advertisement
8. Information Menu
9. Slave Switcher Input Selection
_______ CHL represents the input channel number (CHL04). In menus 1 and 2, VID
Picture Controls (line doubler/line quadrupler converter)
_______ There are three ways to exit a display at
_______ Picture Controls for CONT, COLOR,
Extron • System 4 xi Switcher Series • User's Manual
Use
to get this menu, and then press
Menu 8 allows the internal system information to be displayed on the LCD
screen, eliminating the need to open the System 4xi cover to see the switch
settings. The Information Menu is for display only; no changes can be made
from here.
Press
to select this menu set.
The five submenus are shown in the example to the left.
Press
or
to step through and display the information choices.
The diagram to the left shows some examples of what the settings could be.
Press
or any input button at any time to exit.
Press
to go to Menu #0 and then
If the System 4xi is not set up for a Slave input, this menu will not appear.
Because the System 4xi has four input buttons, if it uses a slave switcher,
Menu 9 is used to select a Slave input from the Front Panel. Use the
buttons to select from Input 4 through the highest input number available. (e.g. If
a System 8 P
switcher is used as a slave, the input channels available in
LUS
Menu 9 will be 4 through 11.)
When the input is selected, its video format is also displayed.
Press
to select the displayed channel.
Press
to go to Menu #0 and then
(VID04) and AUD (AUD04) are used because in those menus video and audio
are handled separately.
The number of Picture Controls depends upon
the System 4xi model. (See Figure 3-2.) Each
Picture Control button will display its current
setting. From this display, adjustments
can be made and saved.
any time, without saving new settings.
1. Press the same Picture Control
button.
2. Press any input button (1 thru 4).
3. Press
to go to Menu #0 and
then
to go to the Default screen.
and TINT are not available for RGBLD/
RGBLQ inputs.
Figure 3-6. System 4 xi Picture Controls Display Menu Flowchart
Chapter 3 • Using the System 4 xi Front Panel
to go back to the Default Menu.
to go back to the Default Menu.
Default Screen
Not on System 4C
HORIZ. SHIFT
00
Press H SHIFT to Exit
CONTRAST ADJ
Press CONT to Exit
Change Setting
Accept/Save Setting
Exit to Menu 0
to select it.
or
Displayed information
->VID 01 RGBS
depends upon video
->AUD 01 +00dB
type, audio level and
breakaway setting.
Active only with VID
or YC type input.
00
COLOR ADJ
00
Press COLOR to Exit
TINT ADJ
00
Press TINT to Exit
DETAIL ADJ
Level 1 OF 4
Press DETAIL to Exit
Pressing an Input Button
at any time will Exit to
Default Menu.
3-10
Advertisement
Table of Contents
