Table of Contents
Advertisement
Chapter 3 • Using the System 4 xi Front Panel
5. Slave Configuration Menu
_______ When looped with other switchers, the System 4 xi is always the Master.
6. LD Sync Configuration Menu*
7. Sync Configuration Menu
3-9
Use
to get to this menu, and then press
Menu 5 is used only to set up the System 4xi for use with a slave switcher. The
default setting is "None".
Press
or
to select from the following options:
- None = The System 4xi has no slave inputs.
- System 8+ = The slave is a System 8 Plus.
- System 10+ = The slave is a System 10 Plus.
- SW6ARMX = The slave is an SW6 ARMX switcher.
- SW4ARMX = The slave is an SW4 ARMX switcher.
- MULTI SYS8/10 Plus = More than one System 8/10 switcher.
Press
to save the selection to memory.
Once set for a slave, an 8th menu will become available for selecting slave
channels. See Chapter 4 for details on slave configurations.
Press
to go to Menu #0 and then
System 4 xi switchers cannot be looped together.
This menu specifies line-doubled/quadrupled sync output format.
Use
to get menu 6, and then press
There are four submenus for menu 6. Each submenu has two selection points,
indicated by the character ">". Use
and then use
or
to change the choices.
H/HVOUT => H Only for separate H & V out or CSync for composite sync out.
SERRA.=> set for Serration Pulses Present or Removed.
HOUT POL=> to set Horizontal Sync for Positive or Negative Polarity.
VOUT POL=> to set Vertical Sync for Positive or Negative Polarity.
If a change is selected, the new selection blinks until it is saved.
Press
to save the new setting.
Press
or any input button at any time to exit.
Press
to go to Menu #0 and then
*LDxi is shown here
This Menu 7 will set up Line-Doubler/Line Quadrupler display mode for
System 4LDxi /4LQxi (see flowchart in Figure 3-7 for menu differences).
Press
to access this menu, and then press
With the cursor in the left position, use
Screen (also called "Demo mode").
With the cursor at the right position, use
or Off.
Press
to accept/save the change.
Press
to go to Menu #0 and then
to go back to the Default Menu.
to step between the two selection points,
to go back to the Default Menu.
or
to select VGA Mode or Split
or
to turn the selected function On
to go back to the Default Menu.
Extron • System 4 xi Switcher Series • User's Manual
to select it.
to select it.
to select it.
Advertisement
Table of Contents
