Table of Contents
Advertisement
Chapter 4 • Connecting Multiple Switchers
System 4xi with SW4/6 ARMX Switchers
_______ Regardless of how the slave switcher input connectors are marked, they must
_______ Jumper E2 inside the SW4/6 must be moved from "Normal" to "Slave Sys4"
Figure 4-2. System 4 xi Master with an SW6 ARMX Slave Switcher
4-3
The picture in Figure 4-2 shows an SW6 ARMX as an example, although it would
also apply to an SW4 ARMX. Connect the video output of the ARMX switcher
(SW4 or SW6) to the last (4th) input of the System 4xi.
conform to the inputs of the System 4 xi . They are: R/C, G/Y/Video, B, H/HV & V.
Note that composite video uses the G/Y connector.
The System 4xi will control the ARMX switcher through the secondary RS-232
port, by way of a System 4xi Slave Adapter described on page 4-2.
position to allow it to act as a slave. (See SW4/6 documentation.)
After making all the cable connections, go to page 4-7 to configure the master/
slave as a system.
Comm Adapter
Rear Panel
INPUT 1
INPUT 2
H/HV
V
H/HV
V
AUDIO
AUDIO
R/C
G/Y
B
R/C
G/Y
B
Laserdisc Player
VCR/VTR with Audio
with S-video Outputs
and Stereo Audio
VCR
Projector
Projector
Projector Communication
Extension Cable
INPUT 3
INPUT 4
H/HV
V
H/HV
V
AUDIO
AUDIO
R/C
G/Y
B
R/C
G/Y
B
SW 6 AR MX
SVGA Compatible
Laptop Computer
Computer
Extron • System 4 xi Switcher Series • User's Manual
2-Channel
Stereo Audio
BNC Cable
OUTPUT
PJ COMM
H/HV
V
AUDIO
RS-232
R/C
G/Y
B
System 4
Slave Adapter
(26-386-01)
* Do not connect Pin #4
or Pin #8 (improper slave
operation will occur)
M
A
N
U
A
L
Control System
Advertisement
Table of Contents
