Extron electronics System 4LQ
xi User Manual page 28

Chapter 3 • Using the System 4 xi Front Panel
Figure 3-4. Example: Configuring System 4 Output Sync for Line Doubled/Quadrupled Sources
_______ A detailed explanation of each menu follows, beginning with Menu #0 .
3-5
Menu #6 is used to set up composite or separate horizontal and vertical sync for
line-doubled/quadrupled images. Follow the numbers in the diagram and
continue.
Press to get the Menu Select Options (Menu #0).
Press or to get
Menu #6 (LD Sync
CFG).
Press to select
this menu. There are
four functions in this
Default
menu as displayed
from the left selection
point. They are listed in
the diagram. Use to
move between the two
selection points, and
then use or to
show the choices, and
leave your choice
displayed before going
to the next function.
From the left selection
point, press or to
choose one of the four
functions.
Press to step to the
second selection point
and press or to
change the selection
for that function. If the
display already shows
what you want, leave it
and go on. The
choices made for this
example are circled.
Press to step back
to the left selection
point. Repeat steps
and until you have
made all of your
changes to this menu.
Press to save
these settings and
press to go to
Menu #0. From there
you may step to
another menu and start
your next setup
procedure, or exit.
Press to exit Menu #0 and go to the Default Menu.
SYSTEM 4LD Power Up
NE
EXTRON V3.11 Display
After 2-3
Displayed information
second
depends upon video
delay
type, audio level and
breakaway setting.
->VID 01 RGBS
->AUD 01 +00dB
1
MENU SELECT
Go to
0.EXIT
Menu 9
MENU SELECT
1.VID MODE CFG
MENU SELECT
2.AUD LEVEL CFG
MENU SELECT
3.HOST BAUDRATE Screen
MENU SELECT
4.RGB DELAY
MENU SELECT
5.SLAVE CFG
2
3
MENU SELECT
6. LD SYNC CFG
MENU SELECT
7.LD CFG
MENU SELECT
8.INFORMATION
MENU SELECT
*Only if configured
9.SWITCH SLAVE
as a Slave switcher
Go to
Men 0
Extron • System 4 xi Switcher Series • User's Manual
Change Entry Point
Change Selection
Accept/Save Selection
Exit to Menu 0
7
4
Select function and move cursor
4 functions, 2 choices each
5
Make selection
LD SYNC CFG
>H/HVOUT=>CSYNC
4
a - Select H/HVOUT =
5
Select H Only
4
b - Select SERRA. =
5
Select PRESENT
4
c - Select HOUT POL =
5
Select NEG
4
d - Select VOUT POL =
5
Select NEG
6