SIGNAL CONNECTION INSTRUCTIONS. SONY THIS SWITCHER HAS BEEN CONFIGURED FOR: CONFIG MODEL SW2 SW3 SW4 SW5 SW6 PROJ COMM CABLE ADAPTER Sony off on off on 26-312-01 Extron • System 4 xi Switcher Series • User’s Manual • P/N 68-408-02 Rev. A...
Page 2
Configuration and Connections Connecting System 4xi to Sony If the System 4xi is already configured for a Sony projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board.
Page 3
______ Secure all of the connector screws. 7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV cable onto the System 4xi output and those on the other end onto the matching BNCs on the Sony connector panel.
Page 4
8a. Plug the 15-pin HD connector of the Projector Communications Extension cable (shown as CC 50') into the PJ Comm port on the System 4xi. The other end has a 9-pin female connector. Plug this end into the 9-pin male D connector on the SY COM adapter and secure the screws.
Page 5
Sony Installation Configuration and Connections System 4xi - Cable Diagram for Stacking Sony Projectors Use the following diagram as a guide when connecting the System 4xi to two Sony projectors. Refer to Sony documentation for further information. Comm Adapter SY COM...