Table of Contents
Advertisement
Power
g
Primary and Redundant AC power connectors — Plug standard IEC power
cords into these connector to connect the switcher to 100 VAC to 240 VAC,
50-60 Hz power sources.
N For the most reliable power, connect the Redundant power cord to either
h
Primary and Redundant power supply indicator LEDs —
Green — Indicates that the associated power supply is operating within
Red — Indicates that the associated power supply is operating outside
Fan(s)
i
Cooling fan(s) — See "Removing and Installing a Fan Module", in chapter 7,
"Maintenance and Modifications".
Front Panel Configuration Port
CONFIG
ENTER
PRIMARY
REDUNDANT
POWER SUPPLY
1
Figure 2-9 — Front panel configuration (Config) port
a
Configuration port — This 2.5 mm mini stereo jack serves the same serial
communications function as the rear panel Remote port, but it is easier
to access than the rear port after the matrix switcher has been installed
and cabled. The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable,
part #70-335-01 (figure 2-10), can be used for this connection.
1
5
9-pin D
Pin 2
Pin 3
Pin 5
Figure 2-10 — Optional 9-pin TRS RS-232 cable
an uninterruptible power source or to a power source that is completely
independent from the primary power source.
normal tolerances.
the normal tolerances or has failed. See chapter 7, "Maintenance and
Modifications" to replace the power supply.
CONTROL
PRESET
VIEW
ESC
FOX 4G MATRIX 3200
FIBER OPTIC DIGITAL MATRIX SWITCHER
6
9
Connection
Computer's RX line
Computer's TX line
Computer's signal ground
FOX 4G Matrix Switchers • Installation
6 feet
(1.8 m)
Part #70-335-01
TRS Plug
Tip
Ring
Sleeve
Tip
Ring
Sleeve (Gnd)
2-11
Advertisement
Table of Contents
