Table of Contents
Advertisement
Switcher Software, cont'd
DSP Configurator Program
Starting the program
N Extron recommends connection via the Ethernet LAN port for the DSP
To run the DSP Configurator Program, click Start > Programs > Extron Electronics
> DSP Configurator > DSP Configurator. The DSP Configurator program starts in
Emulate mode (figure 5-3, on the next page).
Using the program
In the DSP Configurator window in Emulate mode, you can tailor a variety of audio
parameters and then transfer them to the MPX by going to Live mode (connected to
an MPX). You can also switch to Live mode and then tailor the audio settings in real
time, while listening to the audio output with a critical ear. See "Emulate mode vs.
Live mode", later in this chapter.
N There are three possible DSP Configurator displays:
5-4
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
Configurator program.
•
Audio and video I/O page (figure 5-3)
•
Audio-only I/O page
•
Video-only I/O page
The DSP Configurator program always starts in the audio and video I/O page,
as shown in figure 5-3. Three additional control blocks are availalable in the
video-only I/O page. See "Video-only I/O page controls", later in this chapter.
Advertisement
Table of Contents
