Table of Contents
Advertisement
Starting the DSP Conigurator Program
The DSP Conigurator can connect to the switcher via any rear
panel LAN port or the front panel Coniguration port.
NOTE:
Extron recommends connection via an Ethernet LAN
port for the DSP Configurator program.
Start the DSP Conigurator program, as follows:
1.
Click
Start > Programs > Extron Electronics > DSP
Configurator > DSP Configurator
screen opens (see igure 24).
Startup
Figure 24.
TIP: You can also launch the DSP Configurator program
from within the Product Configuration Software.
2.
Select the DTP CrossPoint switcher in the drop-down menu
and click
OK
TIP: If you have only DTP CrossPoint switchers of the
same model, click
to eliminate step 2 in future startups.
The DSP Conigurator program starts in Emulate mode (see
on the next page).
igure 25
NOTE:
in the PC and not sent to the switcher until you select Live
mode and "push" the settings to the switcher. See the
DTP CrossPoint 4K Series User Guide.
DSP Conigurator Screen and Device Selection
.
Always perform the selected action
In Emulate mode, changes and settings are stored
DTP CrossPoint 4K Series • Remote Control
. The DSP Conigurator
31
Advertisement
Table of Contents
