Sensor Type - SATO CL4NX Operator's Manual

Speed
Printing > Speed
The setting range of the print speed is as follows:
The setting range varies depending on the print resolution of the printer.
• 203 dpi: 2 to 10 ips (inch/sec)
• 305 dpi: 2 to 8 ips (inch/sec)
• 609 dpi: 2 to 6 ips (inch/sec)
Note:
Setting the print speed to a level that is too fast may affect the print quality.

Sensor Type

Printing > Sensor Type
Set the type of sensor for sensing the media.
The options are as follows:
• None: Disable the media sensor.
• Gap: Use the transmissive type sensor.
• I-Mark: Use the reflective type sensor.
If you have selected Tear-Off, Dispenser or Cut & Print in Print Mode,
only Gap and I-Mark will be available in the Sensor Type menu.
If you have selected Linerless in Print Mode, only None and I-Mark will
be available in the Sensor Type menu.
Auto-mode
Printing > Auto-mode
When using Auto-mode, the print mode changes automatically according
to the status of the installed option unit.
The options are as follows:
• Enabled: The print mode changes automatically.
• Disabled: The print mode changes according to the setting of the Print
Mode.
Operate in cutter mode if you have installed the cutter unit. However, if you
have set Linerless in Print Mode, operate in linerless mode. Operate in
dispenser mode if you have installed the dispenser unit.
4 Operation and Configuration
CL4NX Operator Manual
71