SATO CL4NX Operator's Manual page 106

4 Operation and Configuration
NTP
Interface > Network > Services > NTP
Set the functions for NTP.
The NTP function gets the time information from the NTP server through
the network and sets the time of the printer.
The setting items are as follows:
1 Enable
2 Error
3 Time Server IP
Enable
Interface > Network > Services > NTP > Enable
Enable or disable the functions for NTP.
The options are as follows:
• Enabled: Enable the NTP function.
• Disabled: Disable the NTP function.
Error
Interface > Network > Services > NTP > Error
Set to show the NTP error message if detected.
The options are as follows:
• Enabled: Shows the error message.
• Disabled: Do not show the error message.
Time Server IP
Interface > Network > Services > NTP > Time Server IP
Set the IP address of the NTP server.
The setting range is from 0.0.0.0 to 255.255.255.255.
The IP address should normally be set to 0.0.0.0 (the default) which
means that global NTP servers will be assigned automatically. Set to a
valid IP if the time synchronization is requested for a specific server.
104
CL4NX Operator Manual
Enable or disable the functions for NTP.
Set to show the NTP error message if detected.
Set the IP address of the NTP server.