3
Remove about 30 cm (11.8") of labels
from the liner , then pass the liner
through the gap of the dispenser unit to the
outside of the printer.
4
Adjust the dispenser roller to the center
of the label.
5
Close the dispenser unit.
6
Close the print head and top cover.
3.5.5
Loading Media with an Optional Dispenser and Liner Rewinder
This section describes the procedures to dispense the label and rewind the liner in the printer.
The routing path of the media is shown in the right
figure.
Label
Liner
1
Refer to steps 1 through 7 of
3.5.1 Loading Media Roll
media.
2
Press the tab at the front of the printer to
open the dispenser unit .
3
4
Section
to load the
3 Loading the Ribbon and Media
5
4
2
1
CL4NX Operator Manual
41