Loading Media Without Using Dispenser - SATO S84 Operator's Manual

3 Loading the Ribbon and Media
3.5.2

Loading Media without Using Dispenser

This section describes the procedure to just load the
media without using the dispenser. The routing path
of the media is shown in the right picture.
When loading the media, make sure that the print side
is facing up.
1
Refer to steps 1 through 6 of
3.5.1 Loading Label with Dispenser
load the media.
2
Turn the head lock lever 
counterclockwise to lock the print head.
3
Press the feed roller and media sensor
assembly  down until the feed lock
latch  is locked.
4
Push the media guide  lightly against the
outermost edge of the media.
5
Close the top cover.
6
After loading the media and ribbon, perform
a test print to make sure that the media is
loaded correctly.
Refer to the Section 4.2.16 Test Print Mode
details on how to perform a test print.
CAUTION
• When closing the top cover, be careful not to pinch your fingers.
46 S84-ex/S86-ex Operator Manual
Feed roller and
media sensor
Section
assembly
to
Media shaft
Media shaft
3
4
for
Media
2
1