4.6.2 Port, 802.1p, IP/DS based
The page allows you to enable Port Based, VLAN Tag or IP/DS mode of COS.
Class of Service Configuration
=Enable High Priority. After Enabled High Priority, the following enabled
Port Based parameter will become High Priority.
Port Base: The selected port equipped with High Priority. The non-selected
port is Low priority. A packet received by a high priority port is handled as
a high priority packet.
VLAN Tag: The switch follows the VLAN tag of the incoming packets to
forward traffic. VLAN Tag priority: high priority -> 4~7 ; low priority -> 0~3
IP/DS: The switch follows the IP TOS / Diff Serve of the incoming packets to
forward traffic. Ipv4 DS and Ipv6 TC: high priority -> 10,18,26,34,46,48,56 ;
low priority -> others
4.6.3 TCP/UDP Port Based
This page allows user to define the Option type of the pre-defined protocols or
user-defined protocols. Select the Option of the Protocol as below figure shown.
Figure 6-2
33
PoE Switch