Hardware Restore Button - EverFocus ES0812-31 User Manual

suggested. The high quality Ethernet cable reduces the lost while power
transmission.
SFP Installation
While install the SFP transceiver, make sure the SFP type of the 2 ends is the same
and the transmission distance, wavelength, fiber cable can meet your request. It
is suggested to purchase the SFP transceiver with the switch provider to avoid any
incompatible issue.
The way to connect the SFP transceiver is to Plug in SFP fiber transceiver fist. The
SFP transceiver has 2 plug for fiber cable, one is TX (transmit), the other is RX
(receive). Cross-connect the transmit channel at each end to the receive
channel at the opposite end.

2.4 Hardware Restore Button

The purpose of this button is to provide a method for the network administrator
to restore all configurations to the default value.
To activate this function, the user should follow the following procedures.
(1) Press the "Load default" button for 3 seconds until you see all the LED blinking.
(2) When LED starts blinking, it means the CPU is executing the "load default"
procedure. You can release the button now.
After completing this procedure, all the factory default value will be restored. It
includes the IP address, the user name, the password and all switch
configurations.
Please noticed that the rest of the switch settings will be erased after this
procedure.
7
PoE Switch