Figure 11
Converting a tabletop model (four-drive model shown)
Setting Up the Rackmount Model
WARNING!
•
The leveling jacks are extended to the floor.
•
The full weight of the rack rests on the leveling jacks.
•
In single rack installations, the stabilizing feet are attached to the rack.
•
In multiple rack installations, the racks are coupled.
•
Only one rack component is extended at any time. A rack may become unstable if more than
one rack component is extended for any reason.
Setting up the rackmount model requires a template, rack enclosure slide rails, and two people or a
mechanical lift to physically install the library in a rack enclosure.
To set up the rackmount model:
1.
Use the template that shipped with the library to mark the location of the mounting hardware on
the mounting rails of the rack enclosure (see
template indicate the top of a U.
30
Installation
To reduce the risk of personal injury or damage to the equipment, be sure that:
Figure
12). The black dots along the sides of the