HP MSL6000 Series User Manual page 115

Table 10 Fault Symptom Codes (continued)
FSC Message
3054 Need 1 Drive Minimum
(No available drive to run diag.)
3055 Memory Allocation Error
(Memory allocation error in diagnostic.)
3057 Invalid Magazine Type
(Unsupported magazine type detected.)
3058 Magazine Type Change Not Handled
(Unsupported magazine type detected.)
3059 Drive Type Not Supported
(Unsupported magazine type detected.)
3060 Zone Sequence Error
3061 Homing Error
(Unable to complete Shuttle Homing
Algorithm.)
ERP
• Install or activate a drive.
Press the Enter button to clear the
•
message.
• Invalid user initiated operation. Set
parameters correctly and try again.
• Cycle power to the library or reboot by
using the LCD touch display. Wait 30
seconds to power up again.
Upgrade firmware if a newer revision
•
exists.
• Press the Enter button to clear the
message.
• Check magazine type.
• Invalid user initiated operation. Set
parameters correctly and try again.
• Upgrade firmware if a newer revision
exists.
Press the Enter button to clear the
•
message.
• Check drive type.
• Invalid user initiated operation. Set
parameters correctly and try again.
• Upgrade firmware if a newer revision
exists.
Press the Enter button to clear the
•
message.
• Invalid user initiated operation. Set
parameters correctly and try again.
• Cycle power to the library or reboot by
using the LCD touch display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
• Cycle power to the library or reboot by
using the LCD touch display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
MSL6000 series tape library user guide 115