HP MSL6000 Series User Manual page 106

Table 10 Fault Symptom Codes (continued)
FSC Message
200A Menu Mode
200C Cart Inaccessible
(For an SDLT drive, indicates the tape is
not in the unloaded state. For an Ultrium
drive, indicates the tape is not ejected.
Cartridge in drive is not accessible from
changer.)
200D Drive In Error
(A general drive error detected by control
task)
200E No Magazine
(Cannot move from changer. Element not
installed.)
200F Removal Prevented
(Receive medium prevent removal from
drive for a fetch.)
106 Troubleshooting
ERP
• Take the library out of the Menu Mode
via the backspace using the LCD touch
display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
• Invalid user initiated operation. Select
parameters correctly and try again.
• Ensure drive is powered on.
• Ensure the drive shows good status
through the drive status window.
• Check the tape cartridge used in the last
operation for damage.
• Reactivate drive using control panel
maintenance menu and reseat drive.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
• Reseat drive.
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for magazine.
• Replace magazine.
• Attempt to unload drive from software. If
fails, power off unit, disconnect from SCSI
bus, and retry operation.
• Invalid host initiated operation. Check
that application is certified to work with
your library and has up-to-date patches.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for firmware tape in drive.
• Check for cleaning tape in drive.
• Press the Enter button to clear the
message.