HP MSL6000 Series User Manual page 131

Table 10 Fault Symptom Codes (continued)
FSC Message
7021 SCSI response not matched to a known
command
(A command response was received from
a SCSI task, but the original command
opcode could not be determined.)
7022 Unexpected state after NonVolConfig
cmd
(After successfully completing a
NonVolConfigPut command, the current
state of the save operation was unknown.)
7023 Unexpected state after SCSI mode cmd
(After successfully completing a
SCSIUpdateMode Parameters command,
the current state of the save operation was
unknown.)
7024 Unexpected state after SCSI init cmd
(After successfully completing a
SCSIInitCommand, the current state of the
save operation was unknown.)
7025 Message is Invalid Map Conversion
Parameters
(GUI Map Parameters are corrupt or
invalid.)
8001 Cartridge reject recovery failed
ERP
Press the Enter button clear the
•
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
Press the Enter button clear the
•
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
Press the Enter button clear the
•
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
Press the Enter button to reboot.
•
• Ensure the drive shows good status
through the drive status window.
• Cycle power to the library or reboot
using the GUI touch screen.
• Check the tape cartridge used in the last
operation for damage.
MSL6000 series tape library user guide 131