HP MSL6000 Series User Manual page 104

Table 10 Fault Symptom Codes (continued)
FSC Message
0B02 Public Ethernet Set IP Error
(The library could not set the IP
parameters)
1001 SCSI Firmware Error
(Internal SCSI task processing error.
Unexpected state or hardware status.)
1002 SCSI FIFO Empty
(The SCSI controller data FIFO is empty
but should contain more data bytes.)
1003 SCSI FIFO Error
(The SCSI controller data FIFO should be
empty but still contains data bytes.)
1004 SCSI Gross Error
(The SCSI controller detected a gross error
condition. Invalid SCSI bus phase or
DMA error.)
104 Troubleshooting
ERP
• Make sure a valid Ethernet address has
been programmed using the LCD touch
display. (Menu -> Maintenance ->
Library)
• Reboot the library
• Turn off power to the library and inspect
connectors and cables.
• Check the SCSI cable connections to
make sure they are secured.
• Make sure the library controller board
has SCSI termination.
• Turn off power to the library and inspect
connectors and cables.
• Check the SCSI cable connections to
make sure they are secured.
• Make sure the library controller board
has SCSI termination.
• Turn off power to the library and inspect
connectors and cables.
• Check the SCSI cable connections to
make sure they are secured.
• Make sure the library controller board
has SCSI termination.
• Turn off power to the library and inspect
connectors and cables.
• Ensure SCSI options are set correctly.
• Check the SCSI cable connections to
make sure they are secured.
• Make sure the library controller board
has SCSI termination.
• Check host SCSI cable and connections.