DataCard SR200 User Manual page 92

LCD Message
Overcool
Supply ENC-B
Wind ENC-B
Supply ENC-T
Wind ENC-T
Other Error
COM Error
86
Possible Cause
Internal temperature error
(temperature is too low).
Supply side motor encoder
(rotation detection) error.
Take-up side motor
encoder (rotation
detection) error.
Supply side motor encoder
(rotation detection) error.
Take-up side motor
encoder (rotation
detection) error.
Other errors
A communication error has
occurred between the
printer and the laminator.
The power of the laminator
is off.
There was a misalignment
in the positions of the
laminator and the card
printer.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Solution
The ambient operating temperature is too low. Use the
laminator within the prescribed range. When starting
up the laminator in a low temperature environment,
the temperature of the interior can remain low even
though the surrounding temperature has gone up.
Turn on the power again after waiting for about one
hour.
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Turn on the power for the laminator.
Fit the laminator and printer to the joining plate
properly. See the Installation guide for more
information.