Menu Display
Settings
Standby
Backside Cool
Bend Remedy
Temp Level
Speed
Heat Roller
HR Control
Power Saving
Setting
Display
Counter
Mode
Contrast
Buzzer
ON or OFF
Unit No
Choose from 1 to 10
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Front Wait
Back Wait
On
Off
Enable
Disable
OFF or up to 60
minutes
•
Total Cnt
•
Head Cnt
•
Free Cnt
•
Cleaning Cnt
•
Error Cnt
Counter
Laminator Stat
0
Function
Displays the value set using the Status Monitor.
Displays the value set using the Status Monitor.
Displays the value set using the Status Monitor.
See
"Bend Remedy tab" on page 36
If installed, displays the value set using the Status Monitor.
"Bend Remedy tab" on page 36
See
Displays the value set using the Status Monitor.
Displays the value set using the Status Monitor.
Use the up and down arrow keys to select the card counter type:
•
Total is the default setting, and displays the number of
cards printed. The Total counter cannot be reset.
•
Head displays the number of complete dye panels. The
Head counter cannot be reset, however, it automatically
resets itself when the print head is replaced.
•
The Free counter displays the number of cards that have
printed. The Free counter can be reset by the user.
Choose the information to display on the panel.
Displays the LCD panel contrast using 7 gradations from
-3 (low contrast) to +3 (high contrast). The default setting is 0.
Displays whether the electronic beep sound is ON or OFF.
The sound can indicate an error, when fewer than 20 cards
remain in the card hopper, or to confirm a menu selection.
Assign the unit number when more than one printer is
connected to a PC. Each unit attached to a PC must have a
unique number. After choosing the unit number, press the
Enter key and then the Exit key. "Please, power off" is
displayed on the LCD panel. Power the printer off and then
back on.
for more information.
for more information.
53