DataCard SR200 User Manual page 62

Menu Display Settings
Effective IP
Network>IPv6
Adrs Config
Setting:
IP Address
Prefix Len
Gateway
Session TimeOut
MAC Address
IPSec Mode
IPSec Type
56
Subnet Mask
Gateway
Auto
Manual
OFF or up to 60 minutes
ON
OFF
not Setting
Preshard
Certificate
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Function
The default Subnet Mask of the printer is 255.255.255.0. If
you do not use DHCP, ask your network administrator for the
Subnet mask.
The default Gateway of the printer is 192.168.0.1. If you do
not use DHCP, ask your network administrator for the Subnet
mask.
The IP address the printer uses.
Method to set the IP address if the network uses IPv6.
The printer does not have an default IPv6 IP address. If Adrs
Config is set to Auto and the printer is not connected to a
network, None is displayed.
The default prefix length is 64.
The printer does not have a default IPv6 Gateway. If Adrs
Config is set to Auto and the printer is not connected to a
network, None is displayed.
Shows how many minutes the driver should wait without
using the printer to stop the network session between the PC
and printer.
The MAC Address is unique to each printer. The MAC
Address is displayed and cannot be changed.
Displays whether Internet Protocol (IP) Security is On or Off.
After setting up security using a PC and USB connection, this
setting cannot be changed.
Displays the type of IP Security set using the Status Monitor.
• Not Setting, no IP Security.
• Preshard, using a preshared key for encryption.
• Certificate, using a public key certificate for encryption.