DataCard SR200 User Manual page 50

Error Code Displayed Message
0104F000 The temperature of the retransfer
heating roller is too high.
0104F100 The retransfer heating roller is faulty.
0104F200 The thermistor of the retransfer heating
roller is faulty.
0104F300 The temperature of the bend remedy
heating roller is too high.
0104F400 The bend remedy unit is faulty.
0104F500 The thermistor of the bend remedy
heating roller is faulty.
0104F600 The operating ambient temperature of
the printer is too low.
0104F800 The temperature of the thermal head is
too high.
0104**** A hardware error has occurred.
01051A00 Printer command is incorrect.
01052000
01052100 A security key has already been set. A
new security key cannot be specified.
01052200 Entry does not match the preset security
key.
01052300 Security key has not been specified. The
security lock function is not enabled.
01052400 Printer command is incorrect.
01052600
01052700 Ink ribbon specification is incorrect.
01052A00 Printer command is incorrect.
01052B00 Magnetic encoding data is incorrect.
01052C00 IC encoder is not installed.
01052D00 Magnetic encoder is not installed.
01052E00 Optional devices are not installed.
0105**** A command error has occurred.
010B****
44
Solution
Turn the power off and on again. If the same
problem recurs, turn off the power and contact your
service provider.
Check the temperature. If the same problem recurs
within the range of operating ambient temperature,
turn off the power and contact your service
provider.
Turn the power off and on again. If the same
problem recurs, turn off the power and contact your
service provider.
Contact your service provider.
—
—
—
Contact your service provider.
Ensure that the printer driver's ink setting matches
the installed ink ribbon.
Contact your service provider.
Check the card specifications.
—
—
—
Contact your service provider.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide